This little sucker probably doesn't need much explaination.
It's use is pretty obvious at a glance, but I'll give a
brief explaination
just to give this page a little more meat
for those wanting to know a little more.
I wanted to make an adaptor that would let me use Super
NES controllers on my NES cause they're more comfortable
in most people's hands than the original boxy NES control
pads. The wiring is a snap. (More detailed information regarding
this subject can be found
here.)
The toughest part was making a simple case to house the
innards, which wasn't really that hard at all. I just gutted
an old RF switch and used the plastic casing. (Who really
uses that RF crap these days anyhow?) Not much else to say
about it. The pictures should pretty much explain anything
I might be leaving out. It's a relatively simple project
for any first-time NES modder.